back to product overview

Air heater with highly flexible connection hose

Airtherm air heater100 °C

The Airtherm air heater was specially designed for heating compressed air. The air in the connection heat is heated, which is equipped with a ceramic heating element and the appropriate sensor. The feed connection is via a highly flexible line in which both compressed air and also the electrical connection are integrated. The air and electrics are separated in a connector housing.

Depending on requirements, the air temperature can be set up to max. 100°C (measured at the pistol nozzle). The compact design permits easy integration into existing systems

Applications:

Painting technology: automatic paint spraying systems, painting robots, manual spraying, prevention of condensation

Breathing air heating (protective wear): in fire fighting, chemical industry, tank cleaning

General mechanical engineering For control purposes, our HT 40 controllers, the HT 55L with special air software (connection of two Airtherms possible) or an appropriately approved Airtherm controller for the Ex version can be used.

Airtherm air heater system Components for the Ex protected area

Operating temperature 20 to 100 °C
Connection thread G ¼
Manufacturing lengths of the com- pressed air line 2.5 m, 5.0 m, 7.5 m, 10 m (special lengths on request)
Connection housing
Testing and approval PTB 07 ATEX 1051 X
– IP protection type IP 65
– Ignition protection type II 2 G EX e II T3 (gas)
– Ignition protection type II 2 D IP65 T 200°C (dust)
Cable glands
PG 16 – testing and approval EX 80407016 Rose
PG 9 – testing and approval EX 80407016 Rose
Control line
Testing and approval PTB 03 ATEX 1125 X
Heating cartridge
Testing and approval PTB 03 ATEX 1125 X
– IP protection type IP 65
– Ignition protection type T3
Operating voltage 230 VAC
Power rating 500 VA
Airtherm hose (hybrid round cable)
Testing and approval PTB 03 ATEX 1125 X
Air pressure range 1 – 8 bar

powered by webEdition CMS